Think & Tinker, Ltd.
P.O. Box 1606, Palmer Lake, CO 80133
Tel: (719) 488-9640, Fax: (866) 453-8473
Sales:, Support:

SkypeMe at
PREVIOUS navbutn.gif (1645 bytes) NEXT
Model 4200 Series Laminator Manual
Functions and Operation III

C. Temperature Control
  1. These buttons are used to increase and decrease the temperature set-point. As might be expected, the UP arrow increases the temperature, the DOWN (DN) arrow lowers it. After changing the temperature, allow at least 10 minutes for the laminator to reach equilibrium.
  2. The range that the temperature can be adjusted is from room temperature (RT) to 160°C in increments of 1°C. If the actual temperature exceeds 160°C (overshoot), a warning beep will sound and the heat will automatically be reduced.
  • Press the MEASURE (MEAS) button to display the current temperature of the fusion rollers. The temperature will be displayed for 3 seconds before the displays reverts to the set-point.

D. Motor / Speed Control
The speed of the rollers can be adjusted in 6 increments using these buttons (1 being the slowest, 6 the fastest). It is a good idea to record both the temperature and the motor speed for each type of film that you use. The accuracy of the Think & Tinker lamination controller allows you to return to the same operating parameters with the touch of a couple of buttons.
This momentary switch is used to turn off the drive motor. The motor will restart as soon as the button is released. When the rollers are at operating temperature, it is not a good idea to keep this button depressed for long periods of time as damage to the silicone coating may result.
This momentary switch is used to reverse the rotation of the rollers. It is used to remove jammed substrates as well as neck ties that have been dragged into the laminator.

PREVIOUS navbutn.gif (1645 bytes) NEXT

Established 1990

On the web since 1994

Sales: 1-(719) 488-9640    Tech Support: 1-(719) 488-9640    Fax: 1-(866) 453-8473
Copyright © 1994 - 2014 Think & Tinker, Ltd.