Think & Tinker, Ltd.
P.O. Box 1606, Palmer Lake, CO 80133
Tel: (719) 488-9640, Fax: (866) 453-8473
Sales: Sales@ThinkTink.com, Support: Support@ThinkTink.com
Think
&
Tinker
Ltd.





SkypeMe at
"thinkntink"
PREVIOUS navbutn.gif (1645 bytes) NEXT
On-site Assembly of the GC18 Acid Copper Electroplating Cell
(page 5)


mouse over for larger image
  1. The coupling to the source of compressed air is via a press on fitting that mates to the stand-pipe sticking above the cover plate.
  2. Route the air supply tube so that it will not interfere with placing a board into the tank. It is generally a good idea to have the stand-pipe at the rear of the tank when the tank is installed in a tabletop.
  3. Place the barbed air fitting over the stand-pipe.

mouse over for larger image
  1. Push the fitting onto the stand-pipe and wriggle it back and forth to achieve a airtight seal. The stand-pipe is glued into the sparger manifold and will not turn as you install this fitting.

    Do not glue this fitting onto the standpipe since it will need to be removed if the etching cell needs servicing.


mouse over for larger image
  1. Connect the air sparger to a source of clean, dry, filtered compressed-air. It is a good idea to provide as shut off valve as well as a flow control valve in the air supply line. That way you can turn the air flow on and off without losing the adjustment that you will make in the last step. Needless to say, you should make sure that there is no pressure on the line while the connection is being made.
  2. Clamp a piece of clean copperclad into the board clamp. You should tighten the clamp bolts until they are tight to insure that the board does not come loose and drop into the tank.

PREVIOUS navbutn.gif (1645 bytes) NEXT


Established 1990

On the web since 1994

Payment Processing
Sales: 1-(719) 488-9640    Tech Support: 1-(719) 488-9640    Fax: 1-(866) 453-8473
Copyright © 1994 - 2014 Think & Tinker, Ltd. Updated 2/13/2014 7:36:58 AM