|
Think |
 |
SkypeMe at
"thinkntink"
| Assembling the
Multi-roll Adapter (MRA) (installing the back panel spacers on the Series 3000) |
 |
| Two 1/8" thick spacer plates are shipped with the Series 3000 MRA. These
should be installed between the back panel and the side plate on both sides of the
MRA. During the last design revision, Model 3000 laminators grew in width by approximately 1/4" (6.0mm). The spacers were added to maintain compatibility with older laminators while accommodating, the newer, wider machines (also, so we wouldn't have to throw out a ton of sheet metal components). |
|
| Close this window to return to MRA Assembly | |
