Think
& 
Tinker
Ltd.


SkypeMe at
"thinkntink"
Model 4200 Series Laminator Manual
-Table of Contents 		 Green CirKit PCB Prototyping

Note:  If printing this document, select LANDSCAPE mode in your printer properties dialog box.

   Next NEXT
IMPORTANT SAFETY INSTRUCTIONS
    IMPORTANT SAFEGUARDS
        GENERAL   
        ELECTRICAL  
SERVICE  
INSTALLATION
KNOW YOUR THINK & TINKER 4200 SERIES LAMINATOR
    A. POWER SWITCH 
    B. CONTROL PANEL 
    C. FEED TABLE 
    D. SAFETY SHIELD 
    E. TABLE INTERLOCK LATCH 
    F. FEED GUILD 
    G. HEAT ROLLERS 
    H. IDLER BAR 
    I. PULL ROLLERS 
    J. CIRCUIT BREAKER 
    K. FILM SHAFT & CORE ADAPTERS 
    L. LOCKING COLLARS 
    M. FILM WEB 
    N. NIP POINT 
    O. ROLLER PRESSURE HANDLE 
    P. REAR SLITTER 
    Q. FILM TENSION ADJUSTMENT 
    R. TAKE UP ASSEMBLY
OPERATING INSTRUCTIONS  
    FEED TABLE REMOVAL  
    FILM LOADING & THREADING  
    METHOD USING FILM THREADING CARD
    METHOD FOR TACKING NEW FILM TO EXISTING FILM  
MOUNTING  
    TIPS FOR THREADING PRESSURE SENSITIVE FILM  
    PRE TREATING MOUNTING BOARDS  
    MOUNTING AND OVER-LAMINATION 
    DECALING; PSA OR THERMAL FILM
        FIRST PASS
        SECOND PASS
    MOUNTING ONLY
    RUNNING FOIL
FILM ALIGNMENT PROCEDURE 
FILM TENSION ADJUSTMENT  
CLEARING A FILM JAM
SPEED/TEMPERATURE GUILD THE ART OF LAMINATION 
CARING FOR THE THINK & TINKER MODEL 4200/5200 SERIES LAMINATOR  
APPENDIX 
LOADING DRY-FILM PHOTOPOLYMERS  
TROUBLESHOOTING GUIDE  
SPECIFICATIONS 
Next NEXT

Updated
March, 2008

 
Established 1990
WWW www.thinktink.com
On the web 1994

HOME | CATALOG | SHOPPING CART | PCB PROCESS |  REFERENCE | FAQ | CONTACT
Sales: 1-(719) 488-9640    Tech Support:  1-(719) 488-9640   Fax: 1-(866) 787-6946
Copyright © 1994 - 2008 Think & Tinker, Ltd.