Think & Tinker, Ltd.
P.O. Box 1606, Palmer Lake, CO 80133
Tel: (719) 488-9640, Fax: (866) 453-8473
Sales: Sales@ThinkTink.com, Support: Support@ThinkTink.com
Think
&
Tinker
Ltd.





SkypeMe at
"thinkntink"
PREVIOUS navbutn.gif (1645 bytes) NEXT
Acid-Copper Electroplating Module Model 1000 Manual - Electroplating
Panel vs. pattern plating

Electroplating

Panel vs. pattern plating
There are two main approaches commonly used when electroplating PCB substrates, panel plating and pattern plating.

During panel plating, the entire copper surfaces on both sides of the substrate, as well as the hole walls are plated up to a desired final thickness. While this requires a fairly hefty current source for even a modest size PCB, the end result is a smooth, bright copper surface that is easy to clean and prepare for later processing. A major problem for folks without access to a photoplotter, is the need to use negative artwork to expose the circuit pattern into the more common contrast reversing dry-film photoresists (contrast preserving films have been introduced from time to time but never seem to stay around for very long). When you etch a panel plated board, you generally end up removing most of the material that you plated, so the burden of extra erosion of the anode banks is exacerbated by an increased copper loading in your etchant.

Pattern plating, as the name implies, involves masking off most of the copper surface and plating only the traces and pads of the circuit pattern. Due to the reduced surface area, a much smaller capacity current source is generally needed. Further, when using contrast reversing photopolymer dry-film plating masks (the most common type), a positive image of the circuit is all that is needed. For many prototype PCBs, this artwork can be reliably produced on a relatively inexpensive ink jet printer or pen plotter. Pattern plating consumes less copper from the anode bank and requires that less copper be removed during etching. This reduces bath analysis and maintenance requirements. The downside of the technique is that it requires that the circuit pattern be plated with either tin/lead or an electrophoretic resist material prior to etching. Whichever coating you use, it must be stripped off prior to soldermask application. This increases the complexity and adds another set of wet chemical baths to the overall process.

For more information on any of the following steps go to: Acid Copper Through-Hole Plating

PREVIOUS navbutn.gif (1645 bytes) NEXT


Established 1990

On the web since 1994

Payment Processing
Sales: 1-(719) 488-9640    Tech Support: 1-(719) 488-9640    Fax: 1-(866) 453-8473
Copyright © 1994 - 2014 Think & Tinker, Ltd. Updated 2/13/2014 7:36:56 AM